在皮带输送机运行前，首先要确认皮带输送机设备、人员、被输送物品均处于安全完好的状态；其次检查各运动部位正常无异物，检查所有电气线路是否正常，正常时才能将皮带输送机投入运行。 最后要检查供电电压与设备额定电压的差别不超过±5％。
在皮带输送机运行投入，必须进行以下操作：
1.合上总电源开关，检查设备电源是否正常送入且电源指示灯是否亮。正常后进行下一步操作。
2.合上各回路的电源开关，检查是否正常。正常状态下为：设备不动作，皮带输送机运行指示灯不亮，变频器等设备的电源指示灯亮，变频器的显示面板显示正常(无故障代码显示)。
3.按照工艺流程依次启动各电气设备，上一个电气设备启动正常后(电机或其他设备已达到正常速度、正常状态)再进行下一个电气设备的启动。
4.在皮带输送机运行中，必须遵守被输送物品设计中物品的规定，遵守皮带输送机的设计能力。其次，要注意各类人员不得触及皮带输送机的运动部分，非专业人员不得随意接触电气元件、控制按钮等。 最后，在皮带输送机运行中不能对变频器后级断路，如确定维修需要，则必须在停止变频运行的情况下才能进行，否则可能损坏变频器。
5.皮带输送机运行停止 ，按下停止按钮待系统全部停止后方能切断总电源。
英文如下：
In belt conveyor running into, must carry out the following operations:
1 in total power switch, the power is normal to check the equipment and power indicator light is bright. Normal after the next operation.
2 in each loop of the power switch, check whether it is normal. The normal state : equipment not action, belt conveyor running indicator light does not shine, inverter and other equipment power source guiding lights is bright, the display panel displays normal inverter(no fault code).
3 in accordance with the process of the electrical equipment is started, an electrical device is activated to normal(motor or other device has reached the normal speed, normal state)before the next one electrical device start.
4 in belt conveyor running in, must abide by is transported goods design items, abide by the belt conveyor design ability. Secondly, to the attention of all types of personnel must not touch the conveyor belt moving part, non professional personnel shall not contact with electrical components, control buttons. Finally, in the belt conveyer operation can not be on frequency after the circuit breaker, such as determining the repair need, must stop frequency operation condition can be carried out, which might otherwise damage the transducer.
The 5 conveyor belt running stop, press the stop button to stop all the rear system can cut off the power supply.
(图文www.changrong-jx.com)
|
