1.开启分析机和风机，及空压机，脉冲阀10—20分钟。
2.把控制器上的主机电流调整旋钮顺时针方向调到底。振幅调节旋钮调到中间位置。
3.启动主机，把控制器打到自动位置并打开电源开关，缓慢地关闭风机风阀并注意观察风机电流达到60础时固定，向左或向右旋风机电流调节旋钮并注意观察给料机电流表，电流表指针左右摆动即可。
4.全部打开风机风阀，并快速加大给料量《把振幅调节旋钮顺时针方向旋到底即可》同时观察主机电流，当主机电流达到130础时立即逆时针方向旋动主机电流调节旋钮，给料机电流表指针左右摆动即可。锁紧电流调节旋钮。
5.开机5分钟左右观察风机电流是否在60础—65础《顺时针方向减小风机电流》微调风机电流调节旋钮，风机电流稳定在60础—65础观察5—10分钟，电流符合要求锁紧风机电流调节旋钮。
6.机器运行中如果有轻微落料，微调振幅旋钮《逆时针方向》。
7.注意：电流调好后一般情况不需要再调节主机和风机电流，控制给料量即可。
中译英：
1 open analysis machine and the blower, and the air compressor, the pulse valve 10 - 20minutes.
2 controller host current adjusting knob clockwise moved after all. Amplitude adjustment knob to the middle position.
3 boot host, the controller to automatically position and turn on the power switch, slowly closing the fan air valve and observe the fan current reaches 60A fixed, left or right cyclone machine current adjusting knob and observe the feeder current meter, ammeter pointer swing around.
4 all open fan air valve, and the rapid increase of feed quantity" the amplitude adjustment knob clockwise rotation can be observed at the same time the end" current of main host, when the current reaches 130A immediately anti-clockwise rotating hosts a current regulation knob, feeder current meter pointer swing around. Lock current adjusting knob.
5 starting 5 minutes observation fan current is in the 60A - 65A" clockwise to reduce wind mechanical and electrical flow" fine-tuning fan current adjusting knob, fan stable current in60A -65A was observed in 5- 10minutes, current to meet the requirements of locking fan current adjusting knob.
6 the machine is in operation if there is a slight blanking, trimming knob counterclockwise" amplitude".
7 note: current adjusted well in general do not need to adjust host and fan current, control the feeding quantity.
(图/文www.changrong-jx.com)
|
